![]() Not an expert but have been using CloudReady and have been hanging around this forum for a while. Is there a way to enable this functionality?Ĭloudready version: 96.4.6 (Home Build) stable-channel 64-bit The install completed flawlessly, but I have noticed that there is no Touchscreen functionality. I recently installed CloudReady on a Lenovo Ideapad Flex 15 (20309). The eGalax is not showing up when scanning with i2cdetect -y -r 3.Greetings. ![]() Do I have to stick to the iMX7 naming convention or the one from eGalax? I’m not sure about the GPIO/Interrupt mapping. * M41T0M6 real time clock on carrier board */ So if you enable one of the PCAP controllers disable the pwms */ * the PCAPs use SODIMM 28/30, also used for PWM, PWM, aka pwm2, pwm3. ![]() ![]() ![]() wakeup-gpios: the gpio pin to be used for waking up the controllerĬlock-frequency = /* i2c bus frequency 400 KHz */ Here is the example from the Linux Kernel repo: * EETI eGalax Multiple Touch Controller I’m trying to add a touchscreen with eGalax controller to the device tree and edited the config provided by Toradex (Fusion display). ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |